Junctions

This option allows you to easily use poles or masts longer than six metres.
Use Pergola poles, support mats …..
This solution also allows you to avoid high transport costs.
The mats are delivered to you in two prepared parts, the second part ready to be glued.
The product is delivered to you, apply it, let it dry for 48 hours and sand the expensive glue that is sticking out of the joint with a fine metal saw.

The straight bamboo poles are intended for construction, pergolas, car ports, etc.

The bamboos are milled in our workshop and adapted to the requested diameters.

The stainless steel base is inserted and glued with a suitable product.

The base plate is pre-drilled allowing immediate installation on site as required.

The rotating bamboo poles and masts are intended for the construction and placement of tensioned sails.

The bamboos are milled in the workshop and adapted to the required diameters.

The stainless steel base is inserted and glued with a suitable product.

The plate is pre-drilled allowing immediate installation on site as required.

The ball joint allows you to give the desired inclination and height to your post.

The top fitting allows you to give the necessary traction for the tension of the sail.

The diameters used depend on the size of the sail and the amount of pull required from the ground.

.

The full bamboo cladding system is very fast and very easy to set up.

Little manpower, precision, originality and rigidity.

Solution 1:
The bamboos are cut to size in the workshop and are cut transversely on their lower part .
3cm x 3mm thick slices.
They are slid in corner brackets fixed to the wall for the fixing of bottom and a U
Steel will cover the Bamboo for the upper part .
We do not work and do not recommend these solutions below 6/8 cm diameter.

Solution 2:
Bamboos are cut transversely on both sides and inserted into angles without
superior protection.
The bamboos being perforated in their center for treatment, so no problem of water retention .
The dimensions of the angles depend of course on the diameters of Bambous used.
We do not work and do not recommend these solutions below 6/8 cm diameter.